Connecting The Power Supply; Switching The Projector On - Digital Projection M-Vision Laser 21000 WU Important Information Manual

Important Information

Connecting the power supply

Firmly push the mains connector into the socket
Use only the power cable provided.
Ensure that the power outlet includes a ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.

Switching the projector on

1. Connect the power cable between the mains supply and the projector. Switch on at the switch
next to the power connector. (See Connecting the power supply above.)
2. The indicator lights red to signal that the projector is in STANDBY mode. Press one of
POWER
the following buttons:
•
On the remote control, the
•
On the projector control panel, the
The fans begin working, then the
stops, the
POWER
Page 18
1 2
button
ON
POWER
and indicators both light steady green. The projector is switched on.
LIGHT
Digital Projection M-Vision Laser 21000 WU
1 , then press the ON/OFF switch
button.
POWER
indicator begins flashing green. When the flashing
2 .
Rev A November 2018