Digital Projection E-Vision Laser 15000 Series
Connecting the power supply
1. Adjust the VOLTAGE SELECT switch to the required voltage
2. Firmly push the mains connector into the AC In socket
Voltage selection
The VOLTAGE SELECT switch must be set to match the power supply you are using:
Voltage of power supply used
Position of VOLTAGE SELECT switch
200-240 V~
AC100-130V outlet
100-130 V~
200-240 V~
AC200-240V (single phase) outlet
100-130 V~
Rev B April 2021
page 26
Power Supply
1
2
1
2
Notes
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection
as this equipment MUST be
earthed.
Handle the power cable
carefully and avoid sharp
bends. Do not use a damaged
power cable.
Installation & QuickStart Guide