Connecting The Power Supply; Switching The Projector On; Switching The Projector Off - Digital Projection INSIGHT Dual Laser 4K Series Important Information Manual

Digital Projection INSIGHT Dual Laser 4K Series

Connecting the power supply

Firmly push the mains connector into the socket
press the ON/OFF switch
Use only the power cable provided.
Ensure that the power outlet includes a
ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid
sharp bends. Do not use a damaged power
cable.

Switching the projector on

1. Connect the power cable between the mains supply and the projector. Switch on at the switch
next to the power connector. (See Connecting the power supply above.)
2. Wait until the self-test has completed and the standby indicator on the projector keypad shows
amber. The light source will be off and the projector will be in STANDBY mode.
3. Press on the remote control or the control panel and hold for three seconds, to switch the
ON
projector ON. The power indicator on the control panel will show green, the light source will light
and the shutter will open.

Switching the projector off

1. Press on the remote control or the keypad, and hold for three seconds. The power indicator
OFF
on the keypad will show amber, the light source will go out and the cooling fans will run for a short
time until the projector enters STANDBY mode.
2. If you need to switch the projector off completely, switch off at the mains power switch next to the
power connector and then disconnect the power cable from the projector.
Rev A June 2017
2
.
1
, then
Important Information
Page 15
1
2