Table of Contents
Advertisement
Digital Projection M-Vision 930 Series
Control panel indicators
During power on, all LED indicators become lit while the projector is
running a self test.
At the end of the self test only the
STANDBY
When the projector goes from STANDBY to ON mode, the
indicator is switched off and the
ON
indicator is lit.
The
indicator flashes during cool down.
ON
Indicators
1
ON
ERROR
2
STANDBY
3
Error codes
If the projector detects an error, the red
ERROR
For example, if the lamp door is left open, the
error condition is corrected.
Condition
ERROR indicator behavior
Lamp fail
Flashes once, then pauses, then repeats.
Lamp door open
Flashes twice, then pauses, then repeats.
Fan failure
Flashes three times, then pauses, then repeats.
Over temperature
Flashes four times, then pauses, then repeats.
Filter failure
Flashes five times, then pauses, then repeats.
System error
On.
Installation and Quick-Start Guide
PROJECTOR OVERVIEW
indicator remains lit.
STANDBY
MENU
ON
ERROR
1
2
indicator will flash as shown in the chart below.
indicator will flash twice followed by a pause, then the sequence will repeat until the
ERROR
ENTER
LED STATUS
STANDBY
delay
delay
delay
delay
delay
Notes
INPUT
During startup all LEDs light up
at the same time to indicate the
projector is carrying out a self-test.
STBY
3
Rev C February 2015
page 6
Advertisement
Table of Contents
