Table of Contents
Advertisement
Important Information
Connecting the power supply
Firmly push the mains connector
into the AC IN socket as shown in
the illustration.
Use only the power
cable provided.
Ensure that the power
outlet includes a ground
connection as this
equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Switching the projector on
Connect the power cable between the mains supply and the projector. (See Connecting the
1.
power supply above.)
2.
The
indicator lights green to indicate that the projector is in STANDBY mode. Press one
POWER
of the following buttons:
•
On the remote control, the
•
On the projector control panel, the
The
indicator begins flashing green. In approximately 20 seconds, the startup screen
POWER
appears and the projector is fully switched on.
The first time you use the projector, you can set OSD language from the quick menu. (See
Setting the OSD language in the user manual.)
Switching the projector off
1.
Press
on the remote control or
OFF
your choice. The
the projector will then green solid light for
2.
If you need to switch the projector off completely, disconnect the power cable from the projector.
Page 16
button
ON
POWER
indicator light will flash green until the cool down period has completed,
POWER
Digital Projection E-Vision Laser 5000 Series
button.
POWER
on the control panel, then press again to confirm
mode
STANDBY
Rev A January 2018
Advertisement
Table of Contents
