Connecting The Power Supply - Digital Projection Insight 4K Laser Series Important Information Manual

Digital Projection INSIGHT 4K Laser Series

Connecting the power supply

When the projector is viewed from the back, the AC mains inlet
toward the rear.
Make sure the power switch
connector in firmly.
Use only the power cable provided.
Ensure that the power outlet includes a ground connection as this equipment MUST be
earthed.
Handle the power cable carefully and avoid sharp bends. Do not use a damaged power
cable.
Rev E October 2016
2
above the inlet is in the OFF position, then push the mains
1 2
Important Information
is located on the right hand side,
1
Page 19