Table of Contents
Advertisement
Digital Projection M-Vision 930 Series
Setup menu
•
Orientation
Choose from
,
Desktop Front
Ceiling Front
Ceiling Rear
.
•
Auto Power Off
Set this to
if you want the projector to go into STANDBY mode when no
On
input source is detected for 20 minutes.
•
Auto Power On
•
Set this to
On
if you want the projector to start up immediately when the
mains is connected.
•
Set this to
Off
if you want the projector to go into STANDBY mode when
the mains is connected. In this case, the projector will not start up until the
POWER
button is pressed on the control panel or the remote control.
•
Startup Logo
Set this to
if you want the DP logo to show when the projector is first
On
switched on.
•
Blank Screen
Choose from
,
,
and
Logo
Black
Blue
•
Trigger1
and
Trigger 2
Choose from
,
,
Screen
16:9
TheaterScope
determine what will cause each trigger output to activate.
•
Auto-Source
If this setting is
On
, the projector will automatically search for an active input
source.
•
Infrared Remote
Switch the remote control on and off.
•
Network
Access this submenu to set up a LAN
•
On Screen Display
Access this submenu to adjust the appearance and position of the on-screen
display.
•
Presets
Access this submenu to save up to four presets containing custom
combinations of image settings, or to recall a saved preset.
Operating Guide
,
and
Desktop Rear
.
White
,
,
or
to
4:3
4:3 Narrow
RS232
network connection.
USING THE PROJECTOR
Setup >>
Orientation
Auto Power Off
Auto Power On
Startup Logo
Blank Screen
Trigger 1
Trigger 2
Auto Source
Infrared Remote
Network
On Screen Display
Presets
Select Item
Adjust
Notes
Desktop Front
Off
Off
On
Logo
Screen
16:9
Off
On
[Menu] Return
If you turn the remote control off,
you can only turn it back on again
from the control panel.
Rev C February 2015
page 64
Advertisement
Table of Contents
