Table of Contents
Advertisement
Digital Projection M-Vision 930 Series
Remote control troubleshooting
The remote control is shipped with no battery fitted. Remove the back cover and insert the
supplied cells while observing the correct cell polarity.
If the projector fails to respond to keypress on the remote control, consider the following checks:
•
Does the Transmit indicator flash when a button is pressed?
The Transmit indicator
should be dark when the remote control is not being used and
1
flash when a button is being pressed. If the Transmit indicator fails to flash when a button
is pressed, it might be time to replace the battery. Use only Alkaline AA (LR6) cells for best
results.
•
Is the remote control enabled?
The remote control can be disabled from the menu. Using the control panel:
1.
Open the OSD and navigate to the
2.
Ensure
Infrared Remote
is set to
•
Is the angle of acceptance met?
The projector is equipped with IR sensors at the front and back. If the remote control
transmits from one side, the sensors may not be able to receive the signal. Change your
position so the remote control signal is within the angle of acceptance.
•
Is the projector connected to an input source?
Some buttons on the remote control will only work if the projector is connected to an input
source.
Check if an input source is connected. If necessary, connect an input source and try again.
•
Is the projector in LENS ADJUSTMENT mode?
LENS ADJUSTMENT mode is actrivated when the
ADJUSTMENT mode:
•
The remote control backlight is on.
•
The
Lens Control
OSD page is displayed on the screen.
•
Some remote control buttons are disabled.
To exit LENS ADJUSTMENT mode, either press
times out.
Installation and Quick-Start Guide
menu.
Setup
On
.
button is pressed. In LENS
LENS
MENU
or wait until LENS ADJUSTMENT
REMOTE CONTROL
ON
POWER
|
1
SOURCE
1
2
4
PIC
MUTE
Remote control
ENTER
MENU
USER MEMORY
A
B
GAMMA
O-SCAN
LENS
C-TEMP
3D
2D/3D
SWAP
Notes
OFF
3
5
For information about the
Remote
setting, see
the Operating Guide.
For information about the angle of
acceptance, see
Infrared reception
earlier in this guide.
ASPECT
RATIO
For information about connecting
C
the projector to an input source, see:
•
Selecting an input signal or
SHARP
test pattern
later in this guide.
•
NR
Signal Inputs
in the
Connection Guide.
TEST
•
Main menu
in the Operating
Guide.
3D
FORMAT
For information about LENS
ADJUSTMENT mode, see
Adjusting the lens
guide.
Rev C February 2015
Infrared
Setup menu
in
later in this
page 10
Advertisement
Table of Contents
