Digital Projection M-Vision 930 Series
Selecting an input signal or test pattern
Input signal
•
Connect an image source to the projector. The signal should be automatically detected by the projector, and should be displayed within
two or three seconds.
•
If more than one signal is connected, then select the input you want to display:
•
Press one of the input buttons on the remote control, or
•
Open the On-screen display (OSD) by pressing
an input signal using the
and
UP
Test pattern
To display a test pattern:
•
Open the OSD by pressing
MENU
. Highlight
arrow buttons.
Installation and Quick-Start Guide
OPERATING THE PROJECTOR
. Highlight
from the main menu, press
MENU
Input
arrow buttons. Press
DOWN
ENTER/SELECT
Test Patterns
from the main menu, then select a test pattern using the
and then select
ENTER/SELECT
to confirm your choice.
LEFT
and
Notes
For full details of how to use the
controls and the menu system, see
the
Operating
Guide.
RIGHT
Rev C February 2015
page 19