Digital Projection E-Vision Laser WQ120 Series
Connecting The Power Supply
Adjust the VOLTAGE SELECT switch
Voltage selection
The VOLTAGE SELECT switch must be set to match the power supply you are using:
Voltage of power supply used
AC100-130V outlet
AC200-240V (single phase) outlet
Installation and Quick-Start Guide
to the required voltage, then firmly push the mains connector into the socket
1
1
2
Position of VOLTAGE SELECT switch
CONNECTING THE POWER SUPPLY
.
2
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Notes
Rev A May 2018
page 4