Connecting The Power Supply; Connecting The Power Supply - Digital Projection INSIGHT 4K Laser Series Installation And Quick Start Manual

Digital Projection INSIGHT 4K Laser Series

Connecting The Power Supply

When the projector is viewed from the back, the AC mains
inlet is located on the right hand side, toward the rear.
1
Make sure the power switch 2 above the inlet is in the
OFF position, then push the mains connector in firmly.
Installation and Quick-Start Guide

CONNECTING THE POWER SUPPLY

1 2
Notes
Use only the power cable
provided.
Ensure that the power outlet
includes a ground connection as
this equipment MUST be earthed.
Handle the power cable carefully
and avoid sharp bends. Do not
use a damaged power cable.
Rev C June 2016
page 3