Machine Start-Up - Car-O-Liner CTR12000 Instruction Manual

Car-O-Liner Group AB

5 Machine start-up

41643, ENG - rev. 2, 2016-10
You SHALL make yourself familiar with all the operating and functional el-
ements the power source disposes of: To this aim, fully read the correspond-
ing chapters in this manual attentively before starting up your welding ma-
chine for the first time.
Machine commissioning includes additional preparation and setting-up oper-
ations welding specialists should generally be familiar with. If this manual
gives detailed information on several procedures, then the intention is to
make you familiar with certain features of your welding machine.
These operations are described in chapter 4.
You have performed all the setting-up work and connected the welding ma-
chine to the mains supply and the pressure reducer to the compressed air
supply system. The mains switch A on the front of the power source is OFF.

Turn the mains switch to I (see figure below).
The yellow pilot lamp B at the top right of the control panel lights up and the
CAR-O-LINER logo is displayed on the screen C for about 5 – 10 seconds.
During this time, the machine then performs a self-test (initialization). The
fan and the circulating pump of the cooling unit both start running (you can
hear the noise). Select the desired welding program with the rotary encoder
F. You MUST read the corresponding information in part 2 of this manual
"Control System".
C
A
CTR12000
B
F
E
34