Advertisement
FIGURE 17 Wrapping the Electrical Tape
Step 7: Repeating for the Other Cables
Repeat the connector sealing instructions for the three antenna
connectors, as shown in Figure 18.
FIGURE 18 Repeating for Other Cables
Copyright
©
2019 ARRIS Enterprises LLC. All rights reserved.
Published June 2019, Part Number 800-72105-001 Rev B
Step 8: Creating Cable Drip Loops
Physically mount the AP and antennas at your desired location,
preferably on the same mounting structure.
Form 80-mm to 130-mm (3-in. to 5-in.) drip loops with the cables.
FIGURE 19 Creating Cable Drip Loops
T305 Caution Notices
A caution calls your attention to a possible hazard that can
damage equipment.
CAUTION!
The equipment is intended for installation in a
Restricted Access Location.
CAUTION!
The equipment can be connected to PoE networks
without routing to the outside plant.
Troubleshooting
If required, you can reset the AP to its factory default settings by
pressing the reset button located inside the PoE port. Use the tip
of a pen or a 3-mm flat-blade screwdriver to press the reset
button. Press and hold the reset button for 4 seconds or longer
to restore to factory defaults.
CAUTION!
Do not reset the AP to factory default settings
unless so instructed. (Doing this resets the AP IP address to
192.168.0.1.)
After a reset, you can access the internal AP web interface using
https://192.168.0.1. Your device must use any other address from
192.168.0.2 through 192.168.0.254, with subnet mask
255.255.255.0. The username is super, and the password is sp-
admin.
For More Information
For information on how to configure and manage the AP, refer to
the Ruckus Wireless Outdoor Access Point User Guide, available
from https://support.ruckuswireless.com.
©
2019 ARRIS Enterprises LLC. All rights reserved.
ARRIS, the ARRIS logo, Ruckus, Ruckus Wireless, the Ruckus logo, and
the Big Dog design are trademarks of ARRIS International plc and/or
its affiliates. All other trademarks are the property of their respective
owners.
Page 5 of 5
Advertisement
