Table of Contents
Advertisement
4. Connect one end to a LAN port on the AP, and then connect the other end to your
network's router, switch, or hub.
5. Verify that the power LED on the Access Point is green.
Congratulations! You have completed setting up the Access Point on your network.
To learn how to configure and manage the Access Point, continue reading the next
chapters.
Troubleshooting Installation
If the startup sequence does not work, verify that the network name (SSID) and security
settings (if you enabled it) on the AP match the settings on your wireless device.
Disconnect the AP from the power source, wait 5 seconds, then reconnect it—and
■
wait 60 seconds before attempting a reconnection.
Disconnect and reconnect the AP and the PC.
■
Replace the Ethernet cable with a new one if the relevant LAN port LED is not
■
illuminated. (LEDs in each port light up during a successful connection.)
If all else fails, you can reset the AP to the factory defaults (and start over).
1. Insert a straightened-out paper clip into the reset button hole (located on the back
of the AP.)
2. Press and hold the Reset button for at least eight (8) seconds.
You can now reconnect your computer directly to the AP (as described in
the Access Point to the Administrative Computer"
with installation, using the default network settings.
Installing the Access Point
Troubleshooting Installation
"2. Connect
on
page
25), and then start over
35
- Quick Links:
- Access Point
Hide quick links:
Advertisement
Table of Contents
