Advertisement
FIGURE 5 Attaching the AP and T-bar bracket with the
locking tab
When you are done, the AP is mounted.
Troubleshooting
CAUTION! If required, you can reset the AP to its factory
default settings by using a straightened paper clip to press
and hold the reset button located between the POE IN and
12VDC ports, for six or more seconds. DO NOT DO THIS
UNLESS SO INSTRUCTED. (Doing this resets the AP IP address
to 192.168.0.1.)
NOTE: After a reset, you can access the internal AP web
interface using https://192.168.0.1. Your device must use any
other address from 192.168.0.2 through 192.168.0.254, with
subnet mask 255.255.255.0. The username is super, and the
password is sp-admin. Refer to the Outdoor Access Point User
Guide for information on configuring and operating the AP.
This document is available at https://
support.ruckuswireless.com.
Copyright
©
2021 CommScope, Inc. All rights reserved.
Published June 2021, Part Number 800-72737-001 Rev A
Page 3 of 4
Advertisement
