Troubleshooting Installation - Ruckus Wireless ZoneFlex 2741 User Manual

802.11g outdoor access point

Hide thumbs Also See for ZoneFlex 2741:

Table of Contents

Installing the Access Point

Troubleshooting Installation

If the startup sequence does not work, verify that the network name (SSID) and security

settings (if you enabled it) on the AP match the settings on your wireless device.

Disconnect the AP from the power source, wait 5 seconds, then reconnect it—and

■

wait 60 seconds before attempting a reconnection.

Disconnect and reconnect the AP and the PC.

■

Replace the Ethernet cable with a new one if the relevant LAN port LED is not

■

illuminated. (LEDs in each port light up during a successful connection.)

If all else fails, you can reset the AP to the factory defaults (and start over).

1. Insert a straightened-out paper clip into the reset button hole (located on the back

of the AP.)

2. Press and hold the Reset button for at least eight (8) seconds.

3. You can now reconnect your computer directly to the AP (as described in

Connect the Access Point to the Administrative Computer"

start over with installation, using the default network settings.

"2.

page

22), and then

Table of Contents