Troubleshooting The Installation - Ruckus Wireless ZoneFlex series User Manual

Installation

Troubleshooting the Installation

3. Obtain an Ethernet cable that is long enough to connect the AP to your network's
router, switch, or hub.
4. Connect one end to a LAN port on the AP, and then connect the other end to your
network's router, switch, or hub.
5. Verify that the power LED on the AP is green.
Congratulations! You have completed setting up the AP on your network. To learn how
to configure and manage the AP, continue reading the following sections.
Troubleshooting the Installation
Review the following troubleshooting steps to determine the cause if you are unable to
verify AP operation.
If the startup sequence does not work, verify that the network name (SSID) and security
settings (if you enabled them) on the AP match the settings on your wireless device.
• Disconnect the AP from the power source, wait 5 seconds, reconnect it, and then
wait 60 seconds before attempting a reconnection.
• Disconnect and reconnect the AP and the PC.
• Replace the Ethernet cable with a new one if the relevant LAN port LED is not
illuminated. (LEDs in each port light up during a successful connection.)
If all else fails, you can reset the AP to its factory defaults (and start over).
1. Insert a straightened-out paper clip into the Reset button hole.
2. Press and hold the Reset button for at least six (6) seconds.
You can now reconnect your computer directly to the AP (as described in
AP to the Administrative Computer
using the default network settings.
86
on page 77, and then start over with installation,
ZoneFlex Indoor Access Point Release 104.0 User Guide
Connect the