Table of Contents
Advertisement
LEDs and Reset Button/Diagnostic Ethernet Port
Use the eight LEDs to check the status of the access point and cable modem.
LEDs on the T504, and
Figure 6. T504 LEDs and reset button/diagnostic Ethernet port when the dome is pointing downwards
3
2
1
Table 3.
LEDs and reset button/diagnostic Ethernet port
No. Label
1
POWER
2
CM DS
3
CM US
4
ONLINE
5
DIR
6
AIR
7
2.4 GHz
8
5 GHz
T504 AP Installation Guide, 800-71032-001 Rev D
Table 3
describes the LEDs and the reset button/diagnostic Ethernet port.
4
5
6
Description
o Off: AP off.
o Blinking red: Boot up in process.
o Solid Green: AP on.
o Blinks when searching for downstream (DS), then solid when DS is locked. Also
blinks during CM boot when power is applied.
o Off when DS is searching, and then blinks as upstream power is increased/
ranged and then solid when upstream ranging is complete. Also blinks during
CM boot when power is applied.
o Off until CM DS and CM US are solid ON, then blinks as the CM obtains an IP
address and a configuration file, and then comes online and LED is solid. Also
blinks during CM boot when power is applied.
o On when the Access Point is being managed by a Ruckus Wireless controller.
o Off: The Access Point is operating in standalone mode.
o Solid green: The wireless signal to its uplink AP is good.
o Off: The 2.4GHz WLAN service is down.
o Solid green: The 2.4GHz WLAN service is up and at least one client is associated.
o Solid amber: The 2.4GHz WLAN service is up. No clients are associated.
o Off: The 5GHz WLAN service is down.
o Solid amber: The 5GHz WLAN service is up, but no clients are associated/
connected.
o Solid green: The 5GHz WLAN service is up and at least one client is associated.
7
8
9
Installing the T504
LEDs and Reset Button/Diagnostic Ethernet Port
Figure 6
shows the
19
Advertisement
Table of Contents
