Reading The 7781Cm Leds - Ruckus Wireless SmartCell 8800-S User Manual

Reading the 7781CM LEDs

The six dual-purpose LEDs are used both by the CM part and the AP part of the
7781CM:
• When LED 1 (green LED) is lit, the LEDs are in Access Point mode.
• When LED 2 (white LED) is lit, the LEDs are in Cable Modem mode.
While the 7781CM is booting up, the LEDs are in CM mode. Once bootup is
completed, the LEDs alternate between CM and AP modes.
NOTE The 7781CM LEDs turn off after a while. This is normal operation.
Refer to the following:
• LED Boot Sequence
• LED Online/Steady State
• Reading LEDs in Access Point Mode
• Reading LEDs in Cable Modem Mode
LED Boot Sequence
1 All LEDs blink for a few seconds.
2 LED 2 (white) stays solid on.
3 LEDs 3, 4, 5 and 6 (blue, middle green, yellow and red) blink in sequence.
4 LEDs 4, 5 and 6 (middle green, yellow and red) blink together for a few seconds.
5 LED 3 (blue) goes solid when the link to the AP is established.
6 LED 6 (red) flashes as CM tries to acquire downstream.
• LED 6 (red) goes solid when downstream is acquired.
• LED 3 (blue) flashes to indicate communication across the AP link.
7 LED 5 (yellow) comes on solid when upstream acquired.
8 LED 4 (middle green) on indicates that cable modem came on-line successfully.
LED Online/Steady State
• LED 1 (green) on indicates AP mode.
• LED 2 (white) on indicates CM mode.
• LEDs 3, 4, 5 and 6 (blue, middle green, yellow and red) are on.
The LEDs alternate between CM and AP modes.
ZoneFlex Outdoor Access Point 100.0.0 User Guide, 800-70725-001 Rev B
Getting to Know the Access Point Features
ZoneFlex 7781CM Access Point with Cable Modem
37