Setting Threshold Options - Ruckus Wireless ZoneFlex 7982 User Manual

7. Click Go back to Wireless Configuration to reopen the previous page.
NOTE: Ruckus Wireless APs do not support arbitrary rate values for 802.1X clients (if
client rate limiting attributes are configured on the RADIUS server). ZoneFlex APs
support only those WLAN rate limiting values that can be set using the AP web
interface. If the rate returned by the RADIUS server does not match one of these values
exactly, it will be approximated.

Setting Threshold Options

The following options allow you to fine-tune the "Protection Mode" behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put into effect and when.
Do not customize these options unless you are an experienced network
CAUTION:
administrator or are under the guidance of an IT/support professional.
To customize Protection Mode (Threshold) settings
1. Go to Configuration > Wireless. The Configuration > Wireless > Common page
appears.
NOTE: If you are using a ZoneFlex 7363/7962/7982 AP, go to Configuration > Radio
2.4G or Configuration > Radio 5G.
2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-
ration > Wireless > Wireless [#] page appears.
3. Look for Threshold Settings, and then click Edit Settings. The Configuration >
Wireless > Advanced > Wireless [#] page appears.
4. Review the options listed in
Table 33. Threshold options
Option
Beacon Interval
Table 33, and then make any needed changes.
Description
(The default value is 100.) The value indicates the
frequency interval of the beacon in milliseconds. A
beacon is a broadcast packet sent by the AP to
synchronize the wireless network.
Configuring the Access Point
Configuring Wireless Settings
87