Setting Threshold Options - Ruckus Wireless ZoneFlex 7781CM User Manual

• Auto: Auto allows both encryption algorithms to be used on the same WLAN.
When Auto is selected, the wireless client decides whether TKIP or AES is
used. Note however that allowing TKIP reduces the performance of the
WLAN (as broadcast packets are limited to slower transfer rates), and is
therefore not recommended.
7 Configure the following settings to customize your 802.1X authentication:
• Radius NAS-ID: Enter the Network ID assigned to your Access Point in the
RADIUS server Client list.
• Authentication Server (required): Enter the information needed to establish a
connection between the Access Point and the RADIUS server.
• Accounting Server (optional): Enter the information needed to establish this
connection.
8 Click Update Settings to save and apply the changes. A confirmation message
appears at the top of this page.
NOTE Ruckus Wireless APs do not support arbitrary rate values for 802.1X clients
(if client rate limiting attributes are configured on the RADIUS server). ZoneFlex APs
support only those WLAN rate limiting values that can be set using the AP web
interface. If the rate returned by the RADIUS server does not match one of these
values exactly, it is approximated.

Setting Threshold Options

The following options allow you to fine-tune the Protection Mode behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put into effect and when.
NOTE Do not customize these options unless you are an experienced network
administrator or are under the guidance of an IT/support professional.
1 Go to Configuration > Wireless/Radio 2.4G/Radio 5G. The Configuration >
Wireless > Common page appears.
2 Click the tab for the Wireless # (WLAN) that you want to configure. The
Configuration > Wireless > Wireless [#] page appears.
3 Look for Threshold Settings, and then click Edit Settings. The Configuration >
Wireless > Advanced > Wireless [#] page appears.
ZoneFlex Outdoor Access Point 9.8.1 User Guide, 800-70598-001 Rev B
Configuring Wireless Settings
Configuring Wireless # Settings
95