Setting Threshold Options - Ruckus Wireless ZoneFlex 2925 User Manual

Figure 23. The Configuration > Wireless > Advanced > Common page

Setting Threshold Options

The following options allow you to fine-tune the "Protection Mode" behavior, set
previously on the Wireless > Common page. After activating a Protection Mode, you
can open each Wireless tab and customize the threshold settings, that determine what
is put in effect and when.
Do not customize these options unless you are an experienced network
CAUTION:
administrator or are under the guidance of an IT/support professional.
To customize Protection Mode (Threshold) settings
1. Go to Configuration > Wireless. The Configuration :: Wireless :: Common page
appears.
NOTE: If you are using ZoneFlex 7962 AP, go to Configuration > Radio 2.4G or
Configuration > Radio 5G.
2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-
ration :: Wireless :: Wireless [#] page appears.
3. Look for Threshold Settings, and then click Edit Settings. The Configuration ::
Wireless :: Advanced :: Wireless [#] page appears.
Configuring the Access Point
Configuring Common Wireless Settings
49