Setting Threshold Options - Ruckus Wireless ZoneFlex 7762-S User Manual
802.11g access point; 802.11g outdoor access point; 802.11n access point; dual band 802.11n access point; dual band 802.11n outdoor access point; dual band 802.11n outdoor sector access point; 2.4ghz 802.11n smart wi-fi access point; dual band 802.11n sma
Hide thumbs
Also See for ZoneFlex 7762-S:
- Installation manual (70 pages) ,
- User manual (149 pages) ,
- Datasheet (5 pages)
Table of Contents
Advertisement
Figure 32.
The Configuration :: Wireless :: Advanced :: Common page
Setting Threshold Options
The following options allow you to fine-tune the "Protection Mode" behavior, set
previously on the Configuration > Wireless > Advanced > Common page. After
activating a Protection Mode, you can open each Wireless tab and customize the
threshold settings, which determine what is put in effect and when.
Do not customize these options unless you are an experienced network
CAUTION:
administrator or are under the guidance of an IT/support professional.
To customize Protection Mode (Threshold) settings
1. Go to Configuration > Wireless. The Configuration :: Wireless :: Common page
appears.
NOTE: If you are using a ZoneFlex 7363/7762/7962 AP, go to Configuration > Radio
2.4G or Configuration > Radio 5G.
2. Click the tab for the Wireless # (WLAN) that you want to configure. The Configu-
ration :: Wireless :: Wireless [#] page appears.
3. Look for Threshold Settings, and then click Edit Settings. The Configuration ::
Wireless :: Advanced :: Wireless [#] page appears.
Configuring the Access Point
Configuring Common Wireless Settings
63
Hide quick links:
Advertisement
Table of Contents
