2
Press [Contrast].
If [Contrast] is not displayed, press the [Advanced] tab and then select [Contrast].
3
Select the desired contrast, and press [Enter].
4
Specify the destination, and press <Start>.
•
For details on the procedure, refer to "
•
If you loaded the document in the ADF, this concludes the procedure.
•
If you loaded the document on the document glass, load the next document, and press
[Next Doc]. To finish scanning, press [Complete].
Setting the Resolution
You can set the resolution for scanning. If you set a high resolution, the document will be
scanned clearly, but the size of the created data will be large.
1
Load the document, and press <Scan>.
For details on loading documents, refer to Chapter 1, "Loading Documents" in the User's
Guide.
Basic
Scanning".
(See page 1-2.)
Basic Scan Settings
1-21
1