Transmitting Faxes To A Fax Server (E-Mail Gateway) - Muratec MFX-2590 Quick Manual

5
Enter the transmission date.
You can use the numeric keys.
6
Select [AM] or [PM], press the entry box and enter the transmission time.
• Enter the time in the entry box in the 12 hour format.
• You can use the numeric keys..
7
Press [Enter].
8
Specify the destination, and press <Start>.
For details on specifying the destination, refer to
Note
• After scanning the document, you can check or delete the reserved transmission by
pressing <Job Confirm.  Fax Cancel>.
• To change the specified time after scheduling the transmission, you need to delete
the scheduled transmission and then set it again.

Transmitting Faxes to a Fax Server (E-mail Gateway)

You can transmit to a fax server as if you were transmitting to a regular telephone line.
The e-mail gateway settings need to be registered in advance.
For details on registering an e-mail gateway, refer to Chapter 2, "Specifying the Network
Settings" in the Administrator's Guide.
Note
This function cannot be used in the following cases:
• Real time transmission
• Polling reception.
• F-Code transmission
• Closed transmission
• ID check transmission
1
Load the document, and press <Fax>.
2
Press the [Advanced] tab.
4-20 Various Fax Functions
"Specifying Destinations".
(See page 3-28.)
(See page 5-2.)