Muratec MFX-2590 Quick Manual page 304

Function
Memory Tx This sets whether to give the priority
to memory transmission or to real-time
transmissions when sending faxes.
*1 Option
Note
• Underlined values are the default settings specified at the time of shipment.
• For details on these settings, refer to "Setting Example".
„ List of Other Default Settings
Function
Redial Attempts
Redial Interval
Number of Rings
Dialing Pause
S-Fine Resolution
Rx Reduction Rate
Reduction Margin
Paper Saving
Quick Memory
Transmission
Error Correction
Mode
Service Mode
Description
Description
This sets the number of redials when the other
machine cannot be connected to, for example,
when the other line is busy. Set the redial
interval in "Redial Interval".
This sets the redial interval.
This sets the number of times the machine rings
until fax reception starts when the reception
mode is set to Fax or Tel/Fax. The number of
rings becomes more than the set number when
the machine is in the low power mode.
This sets the default dialing interval used when
the pause option is input.
This sets the scanning resolution to use when
super fine resolution is set for transmission.
When set to 600 dpi, the image quality will
be higher than with 400 dpi, but the machine
may run out of memory when performing the
transmission.
Select from "Auto", which automatically selects
the magnification according to the length of the
document being received, or "100%" to have all
faxes printed out at the same rate of reduction.
This sets at what point the document printout
will extend to the following page if the document
being received cannot fit within the effective
recordable area.
This sets the print method for received
documents.
If this is set to "ON", fax transmission for
multiple documents will begin in order of page
when it has been scanned and stored.
This mode enables any part of a fax that was
not transmitted correctly due to a line error
will automatically be resent.(The destination
machine must also have the same function.)
Do not set this.
Reference
Settings
ON 3-25
OFF
(See page 7-41.)
Reference
Settings
0 - 14 time(s): 3-19
2 time(s)
0 - 5 Minutes : 3-19
1 Minute
0 - 10 time(s): 3-31
2 time(s)
0 - 10 seconds: 3-24
2 seconds
600 dpi 3-21
400 dpi
Auto 3-36
100 %
0 - 3.3 in.: 3-37
1.6 in.
OFF 3-37
H-Page Rx
Duplex Rx
ON −
OFF
ON −
OFF
ON −
OFF
Specifying Default Settings
page
1
2
3
4
page
5
6
7
7-43