| Installing the Switch
C
2
HAPTER
Connecting to a Power Source
C
ONNECTING TO A
To connect a device to a power source:
Insert the power cable plug directly into the socket located at the back of
1.
the device.
Figure 12: Power Sockets
Plug the other end of the cable into a grounded, 3-pin socket.
2.
For International use, you may need to change the AC line cord.
N
:
OTE
You must use a line cord set that has been approved for the socket type
in your country.
Check the front-panel LEDs as the device is powered on to be sure the
3.
Power LED is lit. If not, check that the power cable is correctly plugged in.
If you have purchased a Redundant Power Unit, connect it to the switch and
4.
to an AC power source now, following the instructions included with the
package.
P
S
OWER
OURCE
– 40 –