Introduction; About This Guide; About The Windowall Pro Series Multi-Graphic Processors - Extron electronics WindoWall Pro Series User Manual

Multi-graphic videowall processors
Table of Contents

Advertisement

Introduction

This section provides an overview of the WindoWall Pro Multi-Graphic Processors, including
information about the following:

About this Guide

This guide discusses how to install, configure, and operate the Extron WindoWall Pro Series
multi-graphic processors.
Throughout this guide, the terms "WindoWall Pro" and "processor" are used interchangeably
to see all models of the products.

About the WindoWall Pro Series Multi-Graphic Processors

The WindoWall Pro and WindoWall Pro DI are four-window RGB and video signal
processors designed for videowall systems. Each WindoWall Pro can display up to four
video sources on a single screen in picture-in-picture or picture-by-picture format. The
WindoWall Pro accepts RGB, HDTV component, S-video, and composite video signals on
four fully-configurable inputs and has one scaled output. The processors can switch among
inputs, and provide a full range of picture controls for each window. Configurations can be
saved as presets and recalled at need.
The WindoWall Pro DI is a WindoWall Pro with an HDMI input card installed, providing four
HDMI input connectors.
WindoWall Pro uses a distributed video processing architecture that dedicates a separate
processor to each output device (projector, video cube, or flat panel monitor) in the
videowall system. Each of the windows can show video, HDTV, or high resolution computer
video content. The WindoWall Pro is compatible with most available display devices and
outputs video at resolutions up to 1920x1200 and 2K, and HDTV component up to 1080p.
Because a discrete, real-time processor is dedicated to each display unit in the videowall,
the WindoWall Pro system is fully scalable, supporting display layouts from 1x2 to 3x2 and
larger.
WindoWall Pro systems are available in sets of two or three processors, for 1x2 or 3x2
arrays, with or without HDMI.
All HDMI inputs and outputs on these models support HDCP.
All models can be controlled remotely via the serial interfaces using the Extron Simple
Instruction Set (SIS) commands or the WindoWall Console software, or via an Ethernet LAN
using the WindoWall Pro embedded web pages, SIS commands, or the control software.
About this Guide
About the WindoWall Pro Series Multi-Graphic Processors
Features
Application Diagram
WindoWall Pro Series • Introduction
1

Advertisement

Table of Contents
loading

Table of Contents