Extron electronics WindoWall Pro Series User Manual page 61

DHCP radio buttons
The radio button directs the WindoWall Pro to ignore any entered IP addresses and
DHCP On
to obtain its IP address from a Dynamic Host Configuration Protocol (DHCP) server (if the
network is DHCP capable).
The radio button turns DHCP off. Contact the local system administrator to set
DHCP Off
this control.
IP Address field
The field contains the IP address of the connected WindoWall Pro. This value is
IP Address
encoded in the WindoWall Pro flash memory.
Valid IP addresses consist of four 1-, 2-, or 3-digit numeric subfields separated by dots
(periods). Each field can be numbered from
total per field, are optional. Values of
The factory-installed default address is
equipment at your installation, you can change the IP address to any valid value.
NOTE: IP address changes can cause conflicts with other equipment. Only local
system administrators should change IP addresses.
Gateway IP Address field
The field identifies the address of the gateway to the mail server to be
Gateway IP Address
used if the Windowall Pro and the mail server are not on the same subnet.
The gateway IP address has the same validity rules as the system IP address.
Subnet Mask field
The field is used to determine whether the WindoWall Pro is on the
Subnet Mask
same subnet as the mail server when you are subnetting. For more information, see
Subnetting, a Primer on page 74.
MAC Address field
The Media Access Control (MAC) Address consists of six hexadecimal character pairs
and is used to identify the processor hardware. This address is hard-coded in the unit and
cannot be changed.
through
000
and above are invalid.
256
192.168.254.254
WindoWall Pro Series • HTML Configuration and Control
. Leading zeros, up to 3 digits
255
, but if this conflicts with other
55