Extron electronics WindoWall Pro Series User Manual page 53

ASCII (Telnet)
Command
(Host to Processor)
IP Setup Commands (continued)
View administrator E }
CA
password
E X12#
Set user
password 14 24
NOTE: A user password cannot be assigned if an administrator password does not exist.
E
Clear user
• CU
password 24
View user E }
CU
password
Query session E }
CK
security level
Set verbose E X11$
24
mode
NOTE: The processor can send out unsolicited information (such as notice of a change in volume, input or some other
setting). That is called a verbose (wordy) relationship between the processor and a connected device. For a direct RS-232
or RS-422 connection, the processor is set for verbose mode by default. When the WindoWall Pro is connected via
Ethernet, verbose mode is disabled by default in order to reduce the amount of communication traffic on the network. If
you want to use the verbose mode with a processor connected via Ethernet, this mode must be set to On each time you
reconnect to the processor.
Read verbose E }
CV
mode
Web Browser Specific Commands
Read response from last URL command
E }
UB
URL Encoded (Web)
(Host to Processor)
|
W CA
} X12# |
CU W CU
} |
W %20 CU
|
W CU
|
W CK
} X11$ |
CV W CV
|
W CV
|
W UB
WindoWall Pro Series • Remote Configuration and Control
Response
Additional Description
(Processor to Host)
X13) ]
View password
with leading zeros.
X13) ]
Ipu • Set user password
(4-12 alphanumeric
characters). The password
is case sensitive. Special
characters (spaces or
symbols) are not allowed.
]
Clear the user password only
Ipu •
X13) ]
View password
with leading zeros.
X13& ]
View security level
current connection. For
With tagged
0 = Anonymous
response – verbose
1-10 = Extended security
modes 2 and 3:
level
X13& ]
Pvl
11 = User
12 = Administrator
X11$ ] Enable or disable verbose
mode type
X11$
For
0 = verbose mode and
tagged responses
disabled
1 = verbose mode enabled
2 = tagged responses for
queries enabled
3 = verbose mode and
tagged responses for
queries enabled
Default is 0 for Telnet
connections and 1 for
RS-232 or RS-422 control.
X11$ ]
{Response from command}
View the response to the last
command that was entered.
X13)
, shown
X12#
X13)
, shown
X13&
of the
X13&
:
X11$
.
:
]
47