Extron electronics WindoWall Pro Series User Manual page 16

Mode Activation
1 Hold in the Reset button while applying
power to the WindoWall Pro.
3 Hold in the Reset button until
the Reset LED blinks once (after
approximately 3 seconds). Then, within
1 second press Reset momentarily
(for less than 1 second).
4 Hold in the Reset button until the
Reset LED blinks twice (once after
approximately 3 seconds and
again after 6 seconds). Then, within
1 second press Reset momentarily (for
less than 1 second).
5 Hold in the Reset button until the
Reset LED blinks three times (once
after approximately 3 seconds, again
after 6 seconds, and then again after
9 seconds). Then, within 1 second
press Reset momentarily (for less than
1 second).
NOTE: Mode 5 reset clears most adjustments. To save these settings, use the WindoWall Console
software. Select
WindoWall Console help file for more information).
NOTES:
•
•
•
Reset Modes Summary
Result
Restores the factory-installed firmware. It
does not clear the current configuration.
Turns events on and off. During resetting,
the Reset LED blinks two times if events
are starting or three times if events are
stopping.
• Enables ARP capability.
• Sets the IP address, subnet address,
and gateway address to the factory
defaults.
Sets port mapping to the factory
•
default.
Turns DHCP off.
•
• Turn events off.
The Reset LED blinks four times in quick
succession during the reset.
Performs a complete reset to factory
defaults (with the exception of the
firmware), which includes:
Everything mode 4 does
•
• Reset of almost all real time
adjustments:
•
•
•
The reset LED blinks four times in quick
succession during the reset.
from the
Save Project as
The reset modes listed in the table above close all open IP and Telnet connections
and all sockets.
Each mode is a separate function, not a continuation from mode 1 to mode 5.
Reset mode 2 is not available on the WindoWall Pro products.
Clears all ties, presets, audio or
RS-232 mutes, and I/O grouping.
Resets all IP options.
Removes or clears all WindoWall
Pro files.
menu before you perform this reset (see the
File
WindoWall Pro Series • Installation
Purpose
Mode 1 can be
used to remove a
version of firmware
if incompatibility
issues arise.
Mode 3 is useful
for troubleshooting.
Mode 4 enables
you to set
IP address
information using
ARP and the MAC
address.
It does not replace
any user-installed
firmware.
Mode 5 is useful
if you want to
start over with
configuration and
uploading and also
to replace events.
10