Figure 1-6 Connecting The Ethernet Cable - Silicon Graphics Prism Hardware User's Manual

1: Quick Start Installation and Operation Procedures
10
2. Connect the Ethernet cable to the Ethernet port on the base I/O card, as shown in
Figure 1-6.
Ethernet connector
Connecting the Ethernet Cable
Figure 1-6
3. Connect the monitor-to-graphics cable, as follows (see Figure 1-7):
• Connect one end of the monitor-to-graphics cable to the monitor.
• Connect the other end of the monitor-to-graphics cable to the DVI-I video
connector on the left side of the graphics board on the back of your system.
Note: The System can be connected to a variety of monitors. Your monitor and
monitor cable may differ from those shown. If your monitor has multiple inputs,
ensure that the source switch is set to the correct input port.
U S
B
1
2
3
L 1
4 U P
L IN
K
B 1 -S
1
B 2 -S
2
B 2 -S
1
B 3 -S
2
B 3 -S
1
B 4 -S
2
B 4 -S
1
A G
P -6
A G
P -5
007-4772-002