Electrostatic Discharge; Laser Compliance Statement; Lithium Battery Compliance Statement - Silicon Graphics Prism Hardware User's Manual

Electrostatic Discharge

Laser Compliance Statement

Lithium Battery Compliance Statement

007-4772-002
with your system. If your monitor cable becomes damaged, obtain a replacement cable
from SGI.
SGI designs and tests its products to be immune to the effects of electrostatic discharge
(ESD). ESD is a source of electromagnetic interference and can cause problems ranging
from data errors and lockups to permanent component damage.
It is important that you keep all the covers and doors, including the plastics, in place
while you are operating the system. The shielded cables that came with the system and
its peripherals should be installed correctly, with all thumbscrews fastened securely.
An ESD wrist strap may be included with some products, such as memory or PCI
upgrades. The wrist strap is used during the installation of these upgrades to prevent the
flow of static electricity, and it should protect your system from ESD damage.
The DVD-ROM drive in this computer is a Class 1 laser product. The DVD-ROM drive's
classification label is located on the drive.
Only qualified service personnel should replace the soldered lithium battery(s) in the
system.
Warning:
Replace the battery with the same or equivalent type as recommended by
the manufacturer, or the battery could explode. Discard used batteries according to the
manufacturer's instructions.
Electrostatic Discharge
173