Silicon Graphics Prism Hardware User's Manual page 162

4: Troubleshooting and Diagnostics
Screen "Screen SG-0"
# Screen "Screen SG-1"
Screen "Screen SG-0"
# Screen "Screen SG-1"
140
Configuring the New ServerLayout Sections
In this new XF86Config.Nservers file, perform the following steps:
1. Copy the section beginning:
Section "ServerLayout"
Identifier "Main Layout"
and insert a duplicate copy (or copies) below the existing section, until there is one
copy for each Xserver you will have (do NOT include the original "Main Layout"
copy in this count).
2. While leaving the original ServerLayout section identified as "MainLayout," give
each new ServerLayout section a new name. For example, the first server might be
named "Layout0":
Identifier "Layout0"
the next "Layout1," and so on.
3. Within each new Server Layout section, disable (delete or comment out) every
screen that will not be used in that layout:
"" ""
""
Note: You may assign any number of screens to a single Xserver, but no screen may
be assigned to more than one Xserver.
4. Edit each Server Layout section to make sure than no remaining uncommented
screen lists as adjacent another screen that will be managed by a different Xserver:
"" ""
""
5. Within each Server Layout section, change the input devices to the correct ones for
that Xserver. For example, the first Xserver might use:
InputDevice "Mouse1" "CorePointer"
InputDevice "Keyboard1" "CoreKeyboard"
6. Save the XF86Config.Nservers file.
For an example ServerLayout section from an XF86Config.3server file, see
"Example "ServerLayout" Sections for Three Xservers" on page 141. In this example, the
first two Xservers manage one screen each, while the third Xserver manages two screens.
"" "Screen SG-1"
"" "Screen SG-0"
"" ""
"" "Screen SG-0"
""
""
007-4772-002