Sav: Save Beacon Parameters - ashtech DG16 Reference Manual

If RTCM message type 7 information is enabled, and received from an RTCM type
7 station located within 30 km of any station in the Beacon directory, then the station
in the Beacon directory is replaced with the newly received information.
If information is received from RTCM type 7 station located more than 30 km from
any station in the Beacon directory, then the station is added to the Beacon
directory.
Example
Enter the following command to block RTCM message type 7 from overwriting in
the preceding Beacon stations in the Beacon directory.
$PASHS,BCN,RT7,N
Enter the following command to enable RTCM message type 7 overwriting in the
Beacon directory.
$PASHS,BCN,RT7,Y

SAV: Save Beacon Parameters

$PASHS,BCN,SAV
This command saves the current channel tuning and mode selection in the battery-
backed memory. The saved parameters will be used after a power cycle or after a
reset.
Differential Commands
DEFAULT SETTING
BCN,RT7—ON (Y)
323