Monitoring via the Serial Ports
Receiver status may also be monitored through the serial ports. To communicate with
the receiver via the serial ports, the receiver must be correctly connected to a PC
running communication software such as Magellan's RCS or commercial PROCOMM.
Set and query commands can then be sent to the receiver, and the receiver responds
with data or status messages. Refer to the Z-Xtreme Technical Reference Manual for
more details about serial port communication and for command descriptions and
formats. The following is a partial list of commands that return information on the
receiver status.
Satellite Monitoring
The following commands return information on satellite tracking and status:
$PASHQ,SAT
$PASHQ,STA
Position
The following commands return information on the current receiver position:
$PASHQ,POS
$PASHQ,GGA
Available Memory
The following command will return information on the amount of available memory
and the files stored on the PC card:
$PASHQ,FLS
Remaining Power
The following command will return information amount of power remaining in the
internal battery:
$PASHQ,POW
Setting Receiver Parameters
You can find many of the receiver parameters accessible by the front panel. You can
modify any of these parameters. Additional parameters can be set using the serial
port commands (Refer to the Z-Xtreme Technical Reference Manual).
Saving Parameter Settings
Ordinarily, receiver parameters that have been changed will return to their default
status after a power cycle. The receiver allows you to save changed receiver settings
28
Z-Xtreme Operations and Reference Manual