Sba: Query Sbas Parameters - ashtech DG16 Reference Manual

Function Command
$PASHQ,SBA
$PASHS,SBA,CDU
SBAS Data
$PASHS,SBA,DAT
and
$PASHQ,SBA,DAT
Information
$PASHS,SBA,INF
$PASHS,SBA,INT
$PASHS,SBA,PAR
$PASHS,SBA,RTC
$PASHS,USE,SBA
$PASHS,USP,SBA

SBA: Query SBAS Parameters

$PASHQ,SBA,[c1]
This command queries all of the SBAS parameters where c1 is the optional port
designator for the output of the response. If a port is not specified, the receiver
sends the response to the current port.
Example
Enter the following command to query the SBAS parameters.
$PASHQ,SBA
MOD:OFF
INF:0
CDU:BTN PAR:ON INT:ON RNG:ON
RTCM: 1
PRTA: OFF OFF OFF OFF OFF
PRTB: OFF OFF OFF OFF OFF
PRTC: OFF OFF OFF OFF OFF
SBA: INF DAT SNW SAW
PRTA: OFF OFF OFF OFF
PRTB: OFF OFF OFF OFF
PRTC: OFF OFF OFF OFF
Differential Commands
Table 9.8. SBAS Commands
Query SBAS parameters
Select the SBAS channels to use
Enable the SBAS output messages
Queries the SBAS output messages
Enable or disable the SBAS information
messages
Enable or disable the integrity information
Enable or Disable Partial SBAS corrections
Set SBAS to RTCM message information
Include or exclude all SBAS satellites for
tracking
Include or exclude all SBAS satellites in the
position computation
2 3 6 9
Description Default Page
305
BTH 306
307
308
308
ON 309
310
311
313
No 313
305