Man: Single Manual Sbas Mode - ashtech DG16 Reference Manual

MAN: Single Manual SBAS Mode

$PASHS,SBA,MAN,s1
This command sets the DG16 to Single Manual SBAS mode and has the DG16
search for and track the SBAS satellite you specify for Channel 1. s1 is the 3-digit
SBAS ID number (33 to 64), which will be tracked on Channel 1.
Channel 2 automatically searches for and tracks the best available SBAS signal. If
the best signal is selected for Channel 1, the DG16 uses the next best signal for
Channel 2.
In single mode, the demodulated SBAS data from Channel 1 are available for output
and used in the navigation solution.
MAN: Dual Manual SBAS Mode
$PASHS,SBA,MAN,s1,s2
This command sets the DG16 to Dual Manual SBAS mode and has the DG16
search for and track the SBAS satellite you specify for Channel 1 and 2. s1 is the
2-digit SBAS ID number (33 to 64), which will be tracked on Channel 1. s2 s the 2-
digit SBAS ID number (33 to 64), which will be tracked on Channel 2.
In dual mode, the demodulated SBAS data from both channels are available for
output and used in the navigation solution.
OFF: Disable SBAS Mode
$PASHS,SBA,OFF
This command disables the SBAS mode. After entering this command, the DG16
will no longer track SBAS satellites, and will track 14 GPS satellites.
To reactivate the SBAS mode, issue either the $PASHS,SBA,DAM or
$PASHS,SBA,MAN command to enable either the Automatic or Manual SBAS
mode.
If you issue the $PASHS,SBA,OFF command to disable the SBAS satellites, you can revert the DG16
to 12 GPS channels by entering the $PASHS,GPS,CHN,12 command.
PAR: Partial SBAS Corrections
$PASHS,SBA,PAR, s1
This command enables or disables the partial output of SBAS corrections where
s1 is ON (enable) or OFF (disable).
310 DG14 and DG16 Board & Sensor Reference Manual