Add: Add Frequency - ashtech DG16 Reference Manual

ADD: Add Frequency

$PASHS,BCN,DIR,ADD,f1,c1,f2,c2,f3,d1,d2,[d3,d4,d5,d6,d7]
This command adds a specified Beacon station to the beacon directory. Table 9.15
outlines the parameters.
Table 9.15. $PASHS,BCN,DIR,ADD Parameters
Parameter
f1
c1
f2
c2
f3
d1
d2
d3
d4
d5
d6
d7
The $PASHS,BCN,DIR,ADD command will be NAKed if you enter a station that is
located less than 30 Km from an existing station in the Beacon directory. To replace
a station, or edit one or more station parameters, you must delete the station and
add a new station with the new parameters.
Example
Enter the following command to add the Beacon station at Pigeon Point, CA to the
Beacon directory.
$PASHS,BCN,DIR,ADD,3711.33,N,122.2366,W,287.0,883,100
316
Description
Latitude
Direction of latitude
Longitude
Direction of Longitude
Beacon frequency, KHz
Station ID
Bit rate
Optional. Range in Km
Optional. Health
Optional. Modulation code
Optional. Synchronization type
Optional. Broadcast coding
DG14 and DG16 Board & Sensor Reference Manual
Range
0 to 90.0000
N or S
0 to 180.0000
E or W
283.5 to 325.0
0 to 1023
25, 50, 100, 200, none,
autodetect