Remaining Power
The following command will return information amount of power remaining in the
internal battery:
$PASHQ,POW
Setting Receiver Parameters
You can find many of the receiver parameters accessible by the front panel. You may
modify any of these parameters. Additional parameters may be set using the serial
port commands (Refer to the Z-Family Technical Reference Manual).
Saving Parameter Settings
Ordinarily, receiver parameters that have been changed will return to their default
status after a power cycle. The receiver allows you to save changed receiver settings
so they will be saved through a power cycle. Perform the following steps to save
receiver settings:
From the main menu, press ↑ < 2 seconds repeatedly until
1.
selected.
2.
With
3.
Within the
selected.
Press ↓ <2 seconds and the message "
4.
5.
Press the
6.
Receiver displays "
Getting Started
selected, press ↓ >2 seconds.
SETTINGS
submenu, press ↑< 2 seconds repeatedly until
SETTINGS
↑+↓
<2 seconds to save the receiver settings.
."
Done
SETTINGS
" will be displayed.
Save settings?
is
is
SAVE
43