Timing Pulse And Measurement Strobe (Optional) - ashtech DG16 Reference Manual

$PASHR,PPS
The response message is output in the format:
$PASHR,PPS,f1,f2,c3*hh
Table 6.40 outlines the parameters.
Table 6.40. $PASHR,PPS Message Format
Parameter
f1 Timing pulse output interval (seconds). Timing
pulse output is disabled when this parameter is set
to zero
f2 Timing pulse offset value (milliseconds)
c3 Synchronization parameter setting for GPS time
*hh Checksum
PPS Period
Offset
Synchronization
See the Timing Pulse and Measurement Strobe (Optional) section on page 47 for more information
on the conditions surrounding timing pulse generation, accuracy, and precision.
PRT: Serial Port Baud Rate
$PASHQ,PRT,[c1]
This command queries the baud rate code of the DG16 serial port to which you are
currently connected, where c1 is the optional serial port designator for the output
of the response. If a port is not specified, the receiver sends the response to the
current port. Issue the query command $PASHQ,PAR to see the baud rate codes
for both serial ports.
$PASHR,PRT
The response is output in the format:
$PASHR,PRT,c1,d2*hh
Receiver Commands
Description
DEFAULT SETTING
1 second
0.0000
GPS time synchronized to the rising edge of the
pulse
Range
0 to 99.95
-999.9999 to
+999.9999
R(ising edge)
F(alling edge)
145