Uct,Udd,Apt: Add Point For 3-D Datum Transformation - ashtech DG16 Reference Manual

UCT,UDD,APT: Add point for 3-D Datum Transformation

$PASHS,UCT,UDD,APT,m1,c2,m3,c4,f5,m6,c7,m8,c9,f10,f11,
f12,f13,f14,f15,f16
This commands adds a point for the estimation of 3D datum transformation
parameters where Table 6.58 outlines the parameters. You must enter this
command for each of the seven required data points to compute the 3-D datum
transformation parameters.
Table 6.58. $PASHS,UCT,UDD,APT Parameters
Parameter
m1
c2
m3
c4
f5
m6
c7
m8
c9
f10
f11
f12
f13
f14
f15
f16
164
Description
Latitude of the position in WGS-84
(ddmm.mmmmm)
Latitude sector
Longitude of the position in WGS-84
(dddmm.mmmmm)
Longitude sector
Ellipsoidal height on WGS-84 (mm)
Latitude of the position in the local datum
(ddmm.mmmmm)
Latitude sector
Longitude of the position in the local datum
(dddmm.mmmmm)
Longitude sector
Ellipsoidal height on the local datum (mm)
Sigma latitude of WGS-84 point
Sigma longitude of WGS-84 point
Sigma altitude of WGS-84 point
Sigma latitude of local datum
Sigma longitude of local datum
Sigma altitude of local datum
DG14 and DG16 Board & Sensor Reference Manual
Range
dd—0 to 90
mm.mmmmm—0 to
59.99999
N or S
dd—0 to 180
mm.mmmmm—0 to
59.99999
E or W
0 to 18000
dd—0 to 90
mm.mmmmm—0 to
59.99999
N or S
dd—0 to 180
mm.mmmmm—0 to
59.99999
E or W
0 to 18000
0
0
0
0
0
0