Tag: Rtcm Sc-104 Version - ashtech DG16 Reference Manual

Example
Enter the following command to set the differential station ID number to 0001:
$PASHS,RTC,STI,0001

TAG: RTCM SC-104 Version

$PASHS,RTC,TAG,s1
This command sets the RTCM SC-104 version used by the receiver. s1 is either
V21 (RTCM SC-104 version 2.1), or V22 (RTCM SC-104 version 2.2), or V23
(RTCM SC-104 version 2.3).
TYP: Enable/Disable Output of RTCM Message Types
$PASHS,RTC,TYP,d1,d2
This command enables or disables the output of specific RTCM message types as
well as the message output interval, where d1 is the type number and d2 is value
of the output interval. This command applies to base station mode only. Table 9.7
lists the available message types and range of the output interval setting.
Table 9.7. $PASHS,RTC,TYP Message Types
Type
01 0-99 seconds, where 0 is disabled and 99 is generated continuously
02 0-99 minutes, where 0 is disabled and 99 is generated continuously
03 0-99 minutes, where 0 is disabled and 99 is generated continuously
06 1 = ON, 0 = OFF Default = OFF
09 0-99 seconds, where 0 is disabled and 99 is generated continuously
16 0-99 minutes, where 0 is disabled and 99 is generated continuously
Differential Commands
DEFAULT SETTING
RTC,STI— 0000
DEFAULT SETTING
RTC,TAG— V22
Range
301