Pwr: Receiver Power - ashtech DG16 Reference Manual

Table 6.41 outlines the parameters.
Parameter
c1
d2
hh
Table 6.42 lists baud rate codes and the corresponding baud rates:

PWR: Receiver Power

$PASHS,PWR,OFF
This command turns the receiver power off. Any activity from the serial port turns
on the receiver power.
RID: Receiver Identification Parameters (Format 1)
$PASHQ,RID,[c1]
This command queries the various receiver identification parameters, where c1 is
the optional port designator for the output of the response. If a port is not specified,
the receiver sends the response to the current port.
146
Table 6.41. $PASHR,PRT Message Format
Description
Identifier for the serial port to which you are
currently connected
Baud rate code (see Table 6.42)
Checksum
Table 6.42. DG16 Baud Rate Codes
Code Baud Rate
0 300
1 600
2 1200
3 2400
4 4800
DEFAULT SETTING
PRT—9600
DG14 and DG16 Board & Sensor Reference Manual
A, B, C (optional)
0 to 9
2-character hex
Baud
Code
Rate
5 9600
6 19200
7 38400
8 56800
9 115200
Range