Seq: Verify Rtcm Message Sequence - ashtech DG16 Reference Manual

SEQ: Verify RTCM Message Sequence

$PASHS,RTC,SEQ,c1
This command enables or disables a check on the sequence number of received
RTCM correction messages, where c1 is Y (on) or N (off). When SEQ is enabled,
the remote station must receive two sequential RTCM correction messages before
it starts applying the corrections. This condition is in effect only at beginning of
differential operation, and applies to remote station mode only. You can see
whether message sequence monitoring is enabled or disabled by entering the
$PASHQ,RTC command and checking the SEQ field.
Example
Enter the following command to enable a check of RTCM message sequence:
$PASHS,RTC,SEQ,Y
SLC: Navigational Solution
$PASHS,RTC,SLC,s1,[s1],[s1]
This command sets the corrections type to use in the navigational solution. You
may select more than one type to use in the solution. s1 is the type of correction:
EXT (Serial Port), BCN (Beacon), SBA (SBAS), or WGH (Weighted Multi-base
Solutions).
298
DEFAULT SETTING
RTC,SEQ— N
DG14 and DG16 Board & Sensor Reference Manual