Out: Serial Port For Output - ashtech DG16 Reference Manual

OUT: Serial Port for Output

$PASHS,BCN,OUT,d1,c1,s1
This command directs the Beacon output to the specified serial port. d1 is the
Beacon channel (1 or 2), c1 is the receiver port (A, B, or optional C), and s1 is ON
or OFF.
Example
Enter the following command to direct the Beacon output for Channel 1 to port B.
$PASHS,BCN,OUT,1,B,ON
RST: Reset Beacon Parameters
$PASHS,BCN,RST
This command resets the Beacon parameters to the saved or default settings.
Table 9.20 lists the different methods you can restart the Beacon receiver and the
differences between the methods.
Reset Command or
Action
Power Cycle the
DG16
$PASHS,RST
$PASHS,BCN,RST
$PASHS,INI,x,x,3 or
$PASHS,INI,x,x,1
$PASHS,INI,x,x,0 or
$PASHS,INI,x,x,2
$PASHS,BCN,BBU
RT7: Blocking RTCM Message Type 7
$PASHS,BCN,RT7,s1
This command blocks the RTCM message type 7 from overwriting the preceding
user entered Beacon stations in the Beacon directory where s1 is Y or N.
322
Table 9.20. Restarting the Beacon Receiver
All receiver and Beacon parameters are restored from battery backed-up memory.
The receiver and Beacon restart. All Beacon parameters are restored to defaults.
The Beacon restarts. All Beacon parameters are restored to defaults.
The receiver and Beacon restart. All receiver and Beacon parameters are restored
to defaults.
The receiver and Beacon restarts All receiver and Beacon parameters are
restored from battery backed-up memory.
The Beacon restarts. All Beacon parameters are restored from battery backed-up
memory.
DG14 and DG16 Board & Sensor Reference Manual
Description