Ant: Set Antenna Offsets - ashtech DG16 Reference Manual

$PASHS,ANH,3.534
$PASHQ,ANH,[c]
This command queries the antenna height entered into the receiver, where c is the
optional port designator for the output of the response. If a port is not specified, the
receiver sends the response to the current port.
Example
Enter the following command to query antenna offsets to port A.
$PASHQ,ANH,A
$PASHR,ANH
The response is in the format:
$PASHR,ANH,f
where f is the antenna height in meters.

ANT: Set Antenna Offsets

$PASHS,ANT,f1,f2,f3,m1,x1
This command sets the antenna offsets from reference point to antenna phase
center. Table 6.4 outlines the parameters.
Parameter
f1 Antenna height: height measured from the reference point
to the antenna edge
f2 Antenna radius: the distance from the antenna phase
center to the antenna edge
f3 Antenna offset: the offset set from the antenna phase
center to the antenna ground plane.
m1 Horizontal azimuth measured from the reference point to
the antenna phase center with respect to north (WGS-84).
x1 Horizontal distance measured from the reference point to
the antenna phase center.
This command affects message type 1, 9, and 3 significantly.
Receiver Commands
Table 6.4. Antenna Offsets Settings
Description Range Unit
0 to 6.4 meters
0.0 to 9.9999 meters
0.0 to 99.9999 meters
0 to 180.00 ddmm.mm
0 to 99.9999 meters
97