Uko: Ukooa Message - ashtech DG16 Reference Manual

$PASHR,TTT
The response message is in the form:
$PASHR,TTT,d1,m2*cc
Table 8.50 outlines the TTT response message structure.
Field
d1
m2
*hh
Example
Enter the following command to enable TTT event marker on port A
Set: $PASHS,NME,TTT,A,ON
Typical Response:
Table 8.51 outlines the example TTT response message.
Table 8.51. Example TTT Response Message
$PASHR,TTT
6
20:41:02.000000 0
OD

UKO: UKOOA Message

$PASHS,NME,UKO,x,s,[f]
This command enables or disables UKOOA message on port x, where x is the
output port, and y is ON or OFF, and f is the optional message output rate ranging
from 0.05 to 999 seconds depending on the measurement update rate option
installed.
278
Table 8.50. $PASHR,TTT Message Format
Description
Day of GPS week (Sunday = 1; Monday
= 2; Tuesday = 3; etc.)
Time at which the pulse was input
(hh:mm:ss.sssssss)
Checksum
$PASHR,TTT,6,20:41:02.0000000*OD
Item
Header
Day of week (Friday)
Time
Message checksum in hexadecimal
DG14 and DG16 Board & Sensor Reference Manual
Range
1 to 7
00:00:00.0000000
to
23:59:59.9999999
2-character hex
Description