Cutting Plotter/Computer Communication Problems - MUTOH VC-600 User Manual

ValueCut USER MANUAL

7.3 Cutting Plotter/Computer Communication Problems

The messages showed below present problems in relation to cutting plotter/computer communication.
Communication Error
Setup: MISC. key
Try the communication between
your cutting plotter and computer.
If it still does not work, have your
cutting plotter serviced.
Note:
The computer also needs to set up compatible communication parameters to the
cutting plotter set up.
HP-GL/2 Cmd. Error
V5a 2015 Jan
Is the connection cable connected to
the cutting plotter and computer
properly?
Yes
Has the interface setting been
done correctly?
Yes
If your cutting plotter can not recognize the
HP-GL/2 or HP-GL commands, please check the
HP-GL/2 or HP-GL commands applied to your
cutting plotter are used properly.
Refer to Chapter 2 -
Connecting your cutting
plotter.
No
Refer to the "MISC" key in Chapter
3 - Description of Operation for the
port setup.
67
Trouble Shooting
No