Cutting Plotter/Computer Communication Problems - MUTOH ValueCut Series User Manual

7.3

Cutting Plotter/Computer Communication Problems

The messages showed below present problems in relation to cutting plotter/computer
communication.
Communication Error
Setup: MISC. key
Try the communication
between your cutting plotter
and computer. If it still does
not work, have your cutting
plotter serviced.
Note:
The computer also needs to set up compatible communication parameters to the cutting
plotter set up.
HP-GL/2 Cmd. Error
Trouble Shooting
Is the connection cable
connected to the cutting plotter
and computer properly?
Yes
Has the interface setting
been done correctly?
Yes
If your cutting plotter can not recognize
the HP-GL/2 or HP-GL commands, please
check the HP-GL/2 or HP-GL commands
applied to your cutting plotter are used
properly.
Refer to Chapter 2 -
Connecting your cutting
plotter.
No
Refer to the "MISC" key in
Chapter 3 - Description of
Operation for the port setup.
7-5
ValueCut User Manual
No